Makita XTP02Z XTP02 Instruction Manual - Page 8
Operation
View all Makita XTP02Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4. After loading pin nails, push back the magazine in place until it clicks. To remove pin nails, follow the installation procedures in reverse. Nose adapter CAUTION: Always make sure that your fingers are not placed on the switch trigger or the contact element and the battery cartridge is removed before installing the nose adapter. When firing pin nails on the material with easily-marred surfaces, use the nose adapter. To install the nose adapter, place it over the driver guide cover so that the protrusion inside the nose adapter fits to the dent in the driver guide cover. You can store the nose adapter on the holder on the back end of the magazine to keep it from being lost. 4 1 2 3 ► 1 . Groove 2. Hook 3. Screw Hex wrench storage When not in use, store the hex wrench as shown in the figure to keep it from being lost. 1 3 2 ► 1 . Dent 2. Protrusion 3. Nose adapter 4. Holder Hook CAUTION: Do not hang the hook from the waist belt. Dropping the pin nailer, which is caused by the hook accidentally coming out of place, may cause unintentional firing and result in personal injuries. 1 ► 1 . Hex wrench OPERATION Testing the safety system WARNING: Make sure all safety systems are in working order before operation. Failure to do so may cause personal injuries. 1 2 The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. 4 3 ► 1 . Trigger-lock button 2. Switch trigger 3. Contact element 4. Magazine 8 ENGLISH