Marantz DV7010 User Guide - Page 50

Audio is not output or is distorted. The Setup screen Audio 1 menu [96 kHz PCM Out] setting is set to [96 kHz]. Digital output is prohibited on some discs. \ Be sure to make analog audio connections as well as digital connections (page 13). The disc is dirty. \ Refer to 'Disc Care' (page 47). The connection plugs are not inserted fully into the terminals or are not connected. \ Check that all connection plugs are firmly inserted. The connection plug or terminal is dirty. \ Check that the plugs and terminals are wiped clean of dirt, etc. Audio cable connection is wrong. \ Check to make sure that the audio cables are connected correctly (page 13). Connection is made to the stereo amplifier's PHONO input terminal. \ Change connection to any input terminal except PHONO. The pause mode is engaged. \ Press PLAY 3 to exit the pause mode. Stereo amplifier operation is incorrect. \ Check input (CD, AUX, etc.) selector to determine if it is selected for DVD playback. The DVD or CD is recorded in DTS audio. \ DTS audio is only output from the digital output jacks. Connect the digital output on the player to the digital input on a receiver or amplifier with a built in DTS decoder to hear DTS audio. Noticeable difference in DVD and CD volume. DVDs and CDs use different recording methods. \ This is not a malfunction. Caution Static electricity or other external influence may cause malfunctioning of this unit. In this case, unplugging the power cord and then re-plugging it in will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest MARANTZ service center. ENGLISH ADDITIONAL INFORMATION 51