Marantz PM-17SA User Guide - Page 10

ENGLISH ENGLISH FRANCAIS FRANCÇAIS DEUTSCH DEUTSCH NEDERLANDS NEDERLANDS ESPANOL ESPAÑOL TROUBLESHOOTING In case of trouble with the unit, first check the following before calling for service. What seems to be a serious malfunction is often due to a simple operation mistake. If the trouble still persists after checking, please consult your dealer or nearest MARANTZ service agent. The amplifier does not work and the warm-up meter lamp does not light. 1. Check if the power cord is plugged properly into an AC power outlet. The warm-up meter lamp lights but the amplifier will not function. 1. Check the settings of the INPUT SELECTOR switch, VOLUME control and SPEAKERS switches. Sound is produced only from one of the speaker systems. 1. Check the setting of the BALANCE control. 2. Turn power of the set off and change the connections of the left and right speaker systems. If sound is still not output from the same speaker system, check its connection cord or the speaker system itself. Sound is not produced at all. 1. Check the settings of the INPUT SELECTOR switches. 2. Check that at least one of the SPEAKERS switches is pressed in. 3. Check that the speaker cords are connected properly. 4. Check that the connection cords with RCA pin plugs are connected properly. 5. Check the SEPARETE/COUPLED switch position on rear panel. Sound from the analog turntable is not output or very noisy (hum noise). 1. Check that the connection to the PHONO jacks is made properly. 2. Connect the grounding wire of the turntable to the GND terminal on the rear panel of the amplifier set. If it has al ready been connected, try removing it. 3. Check that the cartridge is attached properly to the tone arm. 4. Remove the power plug of the turntable from the power outlet and insert it again by inverting the relationship of the left and right blades with respect to the power outlet slots. 9 ITALINO ITALINO PORTUGUES PORTUGUÊS SVENSKA SVENSKA DANSK DANSK