Marantz SA-14S1 HDAM Circuitry on board of Marantz Unique technology for High - Page 5
Accessories, About the remote control - manual
View all Marantz SA-14S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Preparation Connections Playback ENGLISH Accessories Check that the following parts are supplied with the product. q Owner's manual 1 w Warranty card (for USA 1 e Warranty card (for CANADA 1 r Power cord 1 t Audio cable 1 y Remote control cable 1 u Remote control (RC001PMSA 1 i R03/AAA batteries 2 r t About the remote control Inserting the batteries q Remove the rear cover of w Set two R03/AAA batteries the remote control. in the battery compartment in the indicated direction. Operating range of the remote control Operate the remote control while pointing it at the remote sensor. Approx. 23 ft/7 m 30° 30° y u e Put the rear cover back on. NOTE • Replace the batteries with new ones if the unit does not operate even when the remote control is operated close to the unit. • The supplied batteries are only for verifying operation. • Insert the batteries in the proper direction, following the q and w marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in a fire. • Do not keep the battery in a place exposed to direct sunlight or in places with extremely high temperatures, such as near a heater. • If the battery fluid leaks, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control if it will not be used for a long time. • Dispose of batteries in accordance with local regulations on battery disposal. • The remote control unit may function improperly if rechargeable batteries are used. NOTE The unit may function improperly or the remote control may not operate if the remote control sensor is exposed to direct sunlight or strong artificial light from a fluorescent or infrared light. Settings Tips Appendix 2