Marantz SR7001 User Manual - Page 24

CONNECTING OTHER EQUIPMENT a INPUT 1(TV) INPUT 2(DVD) OUT PUT 1 MPONENT VIDEO Y CB/PB CR/PR INPUT 3(VCR1) INPUT 3(VCR1) INPUT 4(DSS/VCR2) Y CB/PB CR/PR Y INPUT 4(DSS/VCR2) OUTPUT 1 OUTPUT 2 CB/PB CR/PR OUT PUT 2 HDMI Ver1.2 S/VCR2(4) MONITOR MULTI OUT OUT TV(1) DVD(2) VCR1(3) DSS/VCR2(4) MONI. OUT MODEL NO. SR8001 RS-232C XM AC IN SURROUND BACK L R L OUT RC-5 MULTI RC AX. IN T. SS/VCR2 OUT TAPE DC OUT IN OUT IN L 1 1 IR FLASHER RECEIVER IN IN 2 2 CD/CDR EMITTER OUT R MULTI OUT L OUT SL S-VIDEO SBL C PRE OUT SR SBR SW SL SBL C R MULTI SPEAKER /SPEAKER C SUB SPEAKER ON OFF UNSWITCHED 1.25A 150W MAX 7.1CH IN OUT IN OUT IN OUT A AUDIO B R SR (AUX2) SBR SW SWITCHED 1.25A 150W MAX AC OUTLETS 120V 60Hz sf g d a RS232C Connect an external control device or other device for servicing. (Use a straight cable for the connection.) s DC OUT (DC TRIGGER) External devices can be controlled from the SR7001 by connecting them to the DC OUT terminal (12 V). d EMITTER OUT (SR8001 Only) Outputs the remote control signal input to the IR RECEIVER IN terminals. External components can be controlled by connecting them to the EMITTER OUT terminal. f FLASHER IN This receiver can be controlled by connecting a control box or other control device to this receiver. g IR RECEIVER IN (SR8001 Only) This receiver can be operated by remote control without using the internal IR receiver, by connecting an external IR receiver. +12V GND Signal An IR receiver is connected as shown above. Caution: • Wrongly connecting an IR receiver or connecting an IR receiver of the wrong voltage can damage the SR7001, therefore do not do this. • 50 mA of current are supplied to the device connected to the IR RECEIVER IN terminal. • Connecting a device that requires more than 50 mA of current to this receiver will damage this receiver. Before using other devices, carefully check the specifications of those devices. 21 ENGLISH