Maytag HRN11250X User Guide - Page 5

CUSTOMER RESPONSIBILITIES Thank You for purchasing a Maytag water heater. Properly installed and maintained, it should give you years of trouble free service. It is strongly suggested that this new water heater be professionally installed, contact Maytag Customer Service (1-800-788-8899) for recommended installers. Abbreviations Found In This Instruction Manual: • CSA - Canadian Standards Association • ANSI - American National Standards Institute • NFPA - National Fire Protection Association • ASME - American Society of Mechanical Engineers • GAMA - Gas Appliance Manufacturers Association This gas-fired water heater is design certified by CSA INTERNATIONAL under American National Standard/CSA Standard for Gas Water Heaters ANSI Z21.10.1 • CSA 4.1 (current edition). • Read the "Safety Precautions" section, page 3 of this manual first and then the entire manual carefully. If you don't follow the safety rules, the water heater will not operate properly. It could cause DEATH, SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE. This manual contains instructions for the installation, operation, and maintenance of the gas-fired water heater. It also contains warnings through out the manual that you must read and be aware of. All warnings and all instructions are essential to the proper operation of the water heater and your safety. Since we cannot put everything on the first few pages, READ THE ENTIRE MANUAL BEFORE ATTEMPTING TO INSTALL OR OPERATE THE WATER HEATER. • The installation must conform with these instructions and the local code authority having jurisdiction. In the absence of local codes, installations shall comply with the following: In the United States: The National Fuel Gas Code ANSI Z223.1/NFPA 54. This publication is available from the Canadian Standards Association, 8501 East Pleasant Valley Rd, Cleveland Ohio 44131, or The National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02269. • If after reading this manual you have any questions or do not understand any portion of the instructions, call Maytag Customer Service at 1-800-788-8899 for an authorized servicer. • Carefully plan the place where you are going to put the water heater. Correct combustion, vent action, and vent pipe installation are very important in preventing death from possible carbon monoxide poisoning and fires, see figure 1 and 2. Examine the location to ensure the water heater complies with the Facts to Consider About the Location section in this manual. • For California installation this water heater must be braced, anchored, or strapped to avoid falling or moving during an earthquake. See instructions for correct installation procedures. Instructions may be obtained from your local dealer, wholesaler, public utilities or California Office of the State Architect, 400 P Street, Sacramento, CA 95814. • Massachusetts Code requires this water heater to be installed in accordance with Massachusetts 248-CMR 2.00: State Plumbing Code and 248-CMR 5.00. In the Commonwealth of Massachusetts, this product must be installed by a licensed plumber or gasfitter. • Complies with SCAQMD rule #1121 and districts having equivalent NOx requirements. PRODUCT SPECIFICATIONS MODEL NUMBER HRN11240X *HRN31240X HRP11240X *HRP31240X HRN11250Q HRN31250Q HRP11250Q HRP31250Q HRN11250X *HRN31250X HRP11250X *HRP31250X TANK CAPACITY IN GALS (LTRS) 40 (151) 40 (151) 40 (151) 40 (151) 50 (189) 50 (189) 50 (189) 50 (189) 50 (189) 50 (189) 50 (189) 50 (189) TYPE OF GAS NATURAL NATURAL PROPANE PROPANE NATURAL NATURAL PROPANE PROPANE NATURAL NATURAL PROPANE PROPANE BTU RATE 40,000 40,000 35,500 35,500 65,000 65,000 55,000 55,000 40,000 40,000 35,500 35,500 RECOVERY RATE GALS. PER HOUR @ 90°F RISE 41.0 41.0 36.0 36.0 67.4 67.4 57.0 57.0 41.0 41.0 36.0 36.0 * High altitude models have a B.T.U./Recovery Rate 10% less than shown. MINIMUM VENT PIPE INCHES (mm) 3" (76) or 4" (102) 3" (76) or 4" (102) 3" (76) or 4" (102) 3" (76) or 4" (102) 4" (102) 4" (102) 4" (102) 4" (102) 3" (76) or 4" (102) 3" (76) or 4" (102) 3" (76) or 4" (102) 3" (76) or 4" (102) DIAMETER INCHES (mm) 20" (508) 20" (508) 20" (508) 20" (508) 22" (559) 22" (559) 22" (559) 22" (559) 22" (559) 22" (559) 22" (559) 22" (559) DIMENSIONS IN INCHES (mm) HEIGHT TOP OF DRAFT HOOD 63 1/2" (1,613) 63 1/2" (1,613) 63 1/2" (1,613) 63 1/2" (1,613) 65" (1,651) 65" (1,651) 65" (1,651) 65" (1,651) 65" (1,651) 65" (1,651) 65" (1,651) 65" (1,651) 5