Maytag MDB4621AWW Use and Care Guide - Page 11

LIGHT WASH Use this cycle for prerinsed or lightly-soiled loads. Use covered detergent dispenser section. To clear the indicators Press CANCEL!DRAIN before starting the dishwasher to clear all options and cycles. Pre- Rinse Main Rinse Purge t Final Dry Time Water Wash Wash Rinse (min) Usage (gal/L) 140°F (60°C) 61" 4.8/18,0 INSTA WASH Use this cycle for china and crystal. This cycle uses a light wash and a gentle dry. During the heated dry, the heating element cycles on and off. Use covered detergent dispenser section. Pre- Rinse Main Rinse Purge _ Final Dry Wash Wash Rinse 140°F (600c) Time (rain) 58* Water Usage (gal/L) 4.8/18,0 RINSE ONLY Use this cycle for rinsing dishes, glasses, and silverware that will not be washed right away. Do not use detergent with this cycle. Pre- Rinse Main Rinse Purge _ Final Dry Time Water Wash Wash Rinse (rain) Usage (gal/L) 10 2,2/10,0 _A small amount of water runs through the pump to remove soil particles. Anytime during a cycle, press CANCEL/DRAIN. The Cancel/Drain light glows. The dishwasher pauses for about 5 seconds and starts a 2-minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain. To stop the drain You can press CANCEL!DRAIN again to stop the drain immediately. Be sure to drain the dishwasher before starting a new cycle. NOTE: A small amount of water remains in the dishwasher. This is normal. During the first 2 minutes of a cycle Press a new cycle and/or options. After the first 2 minutes of a cycle 1. Press CANCEL!DRAIN. Cancel/Drain glows. The dishwasher pauses for 5 seconds and starts a 2-minute drain (if needed). Let the dishwasher drain completely. 2. Check the detergent dispensers. If the main wash cup has opened and the detergent washed away, refill the cups as needed. 3. Close the door. 4. Press a new cycle and/or options and press START/ RESUME. You can add an item anytime before the main wash starts. Open the door and check the detergent dispenser. If the main wash section is still closed, you can add items. To add items 1. Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door. 2. Open the door. If the main wash detergent dispenser is still closed, add the item. 3. Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle. 4. Close the door firmly until it latches and press START/ RESUME. The dishwasher resumes the cycle after about a 5-second pause. You can customize your cycles by pressing an option. If you change your mind, press the option again to turn the option off. Select a different option if desired. You can change an option anytime before the selected option begins. For example, you can press an unheated drying option anytime before drying begins. After a wash cycle, the dishwasher remembers the options used and uses the same options in the next wash cycle, unless you select new options or press CANCEL!DRAIN. 11