Maytag MDD8000AWS Installation Instructions - Page 4

INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed Parts Supplied Check that all parts are included. B A ■ Pliers ■ 10" adjustable wrench ■ Phillips screwdriver ■ Utility knife ■ Flat-blade screwdriver ■ Level E and ¼" nut drivers or hex sockets ■ Measuring tape or ruler ■ Electric drill drill bit ■ 1½" hole saw bit I Parts needed B A C D F G JH C M A. 72" (182.9 cm) flexible water supply line B. Zip tie C. 2 appropriate sized UL listed wire connectors K L N A. ³⁄₄" UL listed strain relief B. 1.25" hose clamp C. 8 mounting bracket screws D. 4 unit mounting screws E. Drain hose connector F. 4 mounting brackets G. Drain connector spring clamps H. 2 trim strips I. Toe kick brackets J. 2 toe kick bracket screws K. Toe kick trim L. 2 panel fasteners (on some models) M. 10 TORX®† screws (on some models) N. Drain hose Location Requirements IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock. Proper installation is your responsibility. ■ Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances. ■ Install the dishwasher as specified in these instructions. ■ Have everything you need to properly install dishwasher. ■ Keep the dishwasher and water lines leading to dishwasher from freezing. Damage from freezing is not covered by the warranty. ■ This dishwasher is manufactured for indoor use only. ■ Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use. 4