Maytag MED9700S Use and Care Guide - Page 11
withthedryer
View all Maytag MED9700S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Pupt owesrupplcyordthrougthhestrainreliefB. esurethathewireinsulatioonnthe powesrupplcyordisinsidtehestrainreliefT. hestrainreliesf houldhaveatighftit withthedryecr abineatndbeinahorizontpaol sitionD.onotfurthetrightesntrain reliesf crewastthispoint. • Put direct wire cable through the strain relief. ]he strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. Style 2: Direct wire strain relief • Unscrew tile rer'nowtble conduit connector and any screws from a %" (1.9 cm) U[. listed strain relief (UI. marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening. Reaching inside the terminal block opening, screw the removable conduit connector onto the strain relief threads. 4. Now complete installation following 4-wire (recommended) 3-wire (if 4-wire is not available) instructions for your type of electrical connection: Electrical Connection Options If your home has: And you will be Go to Section .... connecting to: 4_"_*'-w"r_e']c"ereptacle A U[. listed, 20/240- 4-wire connecti n (NEMA Type 14-30R) volt minimum, Power supply cord A supply cord* B (_ 30 amp, clryer power 4-wire direct A fused disconnect or 4-wire connection: C A. RemovabJe conduit connector B. Hol_' below terminal block opening C. Strain relief thr_'ad_ (12.7 cm) 3-wire receptacle (NEMA type 10-30R) © 3-wire direct circuit breaker box* A UI. listed, 120/240volt minimum, 30-amp, dryer power supply cord* Direct Wire 3-wire connection: Power supply cord A fused disconnect or 3-wire connection: circuit breaker box* Direct Wire *If local codes do not permit the connection of a cabinet-ground wire, go to "Optional 3-wire connection" section. conductor to the neutral