Maytag MED9700S Use and Care Guide - Page 4
Parts, needed, using, power, Pedestal, Height, Part Number - dryer
View all Maytag MED9700S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here• • Flat-blade screwdriver • Vent clamps • #2 Phillips screwdriver • Adjustable wrench that opens to 1" (2.5 cm) or hex-head socket wrench (for adjusting dryer feet) • Wire stripper (direct wire installations) • I.evel • Caulking gun and compound (for installing new exhaust vent) • Tin snips/new vent installations/ • _/_" nut driver/recommended) • [_pe measure Parts supplied Remove parts packages from dryer drum. Check that all parts are included. Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of different heights separately for this dryer. You may select a 10" (25.4 cm) pedestal or a 15.5' (39.4 cm) pedestal with a storage drawer• The pedestal will add to the total height of the dryer for a total height of approximately 46" (116.8 cm) or 51.5' (130.8 cm/, respectively. For a garage installation, you will need to place the 10' (25.4 cm) pedestal at least 9' (22.9 cm) above the floor. You will need to place the 15.5" (_¢9.4 cm) pedestal at least 3' (7.6 cm) above the floor. 4 Low, ling legs NOTE: Do not use leveling legs if installing the dryer on a pedestal. Parts needed Check local codes. Check existing electrical supply and venting. See "Electrical Requirements" and "Venting Requirements" before purchasing parts. • For close-clearance installations between 31.5' (80.01 cm) and 37' (93.98 cm), see "Plan Vent System" section for venting requirements. Optlonal pedestal f 1_._ /39.4 cm] model shown) The pedestals are available in several colors. lb order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Pedestal Height Color Part Number 10" (25.4 cm) 10" (25.4 cm) White Black MHP1000SQO MHP1000SB0 15.5" (39.4 cm) 15.5" (39.4 cm) White Black MHP1500SQ0 MHP1500SB0 15.5" (39.4 cm) Pacific Blue MHP1500SK0 (9:3.98 era) Mobile home installations require metal exhaust system hardware available for purchase from the dealer from whom you purchased your dryer. For further information, please refer to the "Assistance or Service" section. If using a power supply cord: Use a U[. listed power supply cord kit marked for use with clothes dryers. The kit should contain: • A UI. listed 30-amp power supply cord, rated 120/240 volt minimum. ]he cord should be type SRD or SRDT and be at least 4 ft (1.22 m) long. ]he wires that connect to the dryer must end in ring terminals or spade terminals with upturned ends. • A UI. listed strain relief. Stack Kit Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack Kit. [b order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Ask for Part Number 8212640.