Maytag MED9700S Use and Care Guide - Page 25

Cycle tips • Dry most loads using the [)reset cycle settings. • Refer to the Automatic or Manual Preset Cycle Settings chart (in the "Cycles" section) for a guide to drying various loads. • Drying temperature and Dryness Level are preset when you choose an Automatic Cycle. You can choose a different dryness level, depending on your load by pressing the DRYNESS [.EVE[. button to select MORE or LESS. • If you wish to adjust the cycle length of a Manual Cycle, you must press the MANUAl DRY [[ME (- or +) buttons. Adjust the temperature of a Manual Cycle by pressing TEMP until the desired temperature is selected. NOTE: You cannot choose a Dryness level with Manual Cycles. _,_,_ _d You may follow the progress of your dryer with the drying status indicator lights. Sensing 0 Wet 0 Damp 0 Cool Down O Cycle Complete 0 Extra Care O Control Locked O Sensing When a cycle is first turned oil, the Sensing light illuminates until a wet item is detected. • In an Automatic Cycle, if a wet item has not been detected within 10 minutes, the Sensing light will turn off and the dryer will shut down. • In a Manual Cycle, if a wet item is not detected after ] 0 minutes the Wet light turns on and the selected cycle continues. Wet The Wet light will turn on when a wet item has been detected in the dryer. The Wet light will remain on until: • The damp dry point is reached in an Automatic Cycle. • [he dryer enters the cool down period in a Manual Cycle. Damp The Damp light indicates that the load has reached the damp dry level. NOTE: The [)amp light is not used with Manual Cycles. Cool Down The Cool Down light illuminates down for ease in handling. during the cool down [)art of the cycle. Laundry is cooling Cycle Complete The Cycle Complete light illuminates when a drying cycle is finished. If the Extra Care feature has been selected, the Extra Care feature indicator light will also be on. The Cycle Complete light turns off 1 hour after the end of a drying cycle (including the Extra Care cycle of 2 hours), when Off is pressed, or when the door is opened. Extra Care Feature The Extra Care feature light illuminates with the Cycle Complete light. when this option is selected. This indicator stays on Control Locked The Control locked light illuminates when this option is enabled. Indicator lights Other indicator lights on the control panel show Cycle, [_mperature settings selected. and Cycle End Signal [he time display will indicate the estimated or actual time remaining in a cycle. Select the drying cycle that matches the type of load you are drying. See Automatic Manual preset cycle settings charts. AUTOMATIC MANUAL Heavy Duty c27;' CYCLES Timed Dry preset or Cycle Centrol knob Automatic Cycles Automatic Cycles allow you to match the cycle to the load you are drying. See the following Automatic preset cycle settings chart. Each cycle dries certain fabrics at the recommended temperature. A sensor detects the moisture in the load and automatically adjusts the drying time for optimal drying. Heavy Duty Use this cycle to get High heat for heavyweight mixed loads, cotton towels or jeans. Normal Use this cycle to get Medium heat for drying sturdy fabrics such as work clothes and sheets. Casual Use this cycle to get Medium heat for drying no-iron fabrics such as sport shirts, casual business clothes and permanent press blends. Delicate Use this cycle to get Low heat for drying synthetic fabrics, washable knit fabrics and no-iron finishes. 25