Maytag MMV4205BAQ Installation Instructions - Page 12
RECIRCULATING, Non-Vented, Ductless
View all Maytag MMV4205BAQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Instructions A. RECIRCULATING (Non-Vented Ductless) INSTALLATION OVERVIEW A1. Attach Mounting Plate to Wall A2. Prepare Top Cabinet A3. Mount the Microwave Oven + AI.__.ATTACH THE MOUNTING PLATE TO THE WALL Attach the plate to the wall using toggle bolts. At least one wood screw must be used to attach the plate to a wall stud. 1, Remove the toggle wings from the bolts. 2, Insert the bolts into the mounting plate through the holes designated to go into drywall and reattach the toggle wings to 3A" onto each bolt. To use toggle bolts: I Mount ng Plate Spacing for Toggles More Than Wall Thickness Toggle Wings = Wall Bolt End 3. Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount the plate. NOTE: Before tightening toggle bolts and wood screw, make sure to coincide bottom line of the Mounting plate with Horizontal line of "Rear wall Template" and then the Mounting plate is properly centered under the cabinet. CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the walt. 4. Tighten all bolts. Pull the plate away from the walt to help tighten the bolts. A2.__U. SE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. 12