Maytag MMV4205BAQ Installation Instructions - Page 16
Installation, Instructions, INSTALLATION, PROCEDURE, EXHAUST, ADAPTOR, PROPER, DAMPER, OPERATION, - diagram
View all Maytag MMV4205BAQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Instructions B5.__M. OUNT THE MICROWAVE OVEN 5. Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 6, Secure blower unit to microwave with the screw. B4. INSTALLATION PROCEDURE FOR EXHAUST ADAPTOR AND PROPER DAMPER OPERATION CHECK 1. Remove and save screw from the panel-outer FOR EASIER INSTALLATION SAFETY, WE RECOMMEND INSTALL THIS MICROWAVE AND PERSONAL THAT TWO PEOPLE OVEN. IMPORTANT: Do not grip or use handle during installation. NOTE: If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord. NOTE: We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf. IMPORTANT: If filler blocks are not used, case damage may occur from over tightening screws. NOTE: When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it tight throughout Steps 1-3. Do not pinch cord or lift oven by pulling cord. 1. Lift microwave, tilt it forward, and hook slots at back bottom edge onto four lower tabs of mounting plate. Exhaust Adaptor and Damper is shipped after being assembled to the filler-upper. 2, Slide exhaust adaptor following the instructions show in diagram. 3, Make sure tape securing damper is removed anc damper pivots easily before mounting microwave 4, Lift damper and Re-screw at same location as (1 ' • You will need to make adjustments to assure proper alignment with your house exhaust duct after the microwave is installed. 2, Rotate front of oven up against cabinet bottom 3. Insert a self-aligning screw through top center cabinet hole. Temporarily secure the oven by turning the screw at least two full turns after the threads have engaged. (It will be completely tightened later.) Be sure to keep power cord tight. Be careful not to pinch the cord, especially when mounting flush to bottom of cabinet. 16