McAfee IIP-S41K-NA-100I Product Guide - Page 21
► To install the ears on the chassis, follow these steps:, Mounting the I-4000 sensor in a rack
View all McAfee IIP-S41K-NA-100I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
McAfee® IntruShield® IPS 4.1 IntruShield Sensor 4000 Product Guide Setting up the I-4000 sensor prior to configuration Positioning the I-4000 ► To install the ears on the chassis, follow these steps: 1 Verify that you have all the parts you will need: two chassis ears and twelve Phillips flathead screws. 2 Attach the first chassis ear to the right side of the chassis. Use a Phillips screwdriver to secure the Phillips flathead screws to the chassis. 3 Repeat this procedure for the other ear. Figure 2: Attaching the mounting ears to the sensor chassis Mounting the I-4000 sensor in a rack McAfee recommends rack-mounting your sensors. The rack-mounting hardware included with the sensors is suitable for most 19-inch equipment racks and telco-type racks. For maintenance purposes, you should have access to the front and rear of the sensor. Caution: Before you mount the sensor in the rack, make sure that power is OFF. Remove the power cable and all network interface cables from the sensor Rack-mount the sensor by securing the rack mount ears to two posts or mounting strips in the rack. The ears secure the sensor to two rack posts, and the rest of the sensor is cantilevered off the ears. Note: You need two people to install the sensor in the rack-one person to hold the sensor and one person to secure it to the rack. 13