McAfee M-2750 Product Guide - Page 17

Setting up the Sensor Redundant power supply 3 Remove a Sensor from the rack Because of the weight of the appliance, McAfee recommends that two people remove the chassis from the rail cabinet. When removing the chassis from the rack, pull chassis forward until you hear the innermost rails snap in place. On each side of the rails, press in the release button as pictured below and continue pulling the chassis. Figure 3-1 Rail release latch for the Sensor Redundant power supply A basic configuration of the Sensor includes one hot swappable supply. You may install a second hot-swappable power supply (purchased separately from McAfee) for redundancy. Each of these modules has one handle for insertion or extraction from the unit as well as a release latch. Figure 3-2 Inserting the power supply for the Sensor Install the power supply Task 1 Unpack the power supply from its shipping carton. 2 Remove the faceplate panel covering the power supply slot. The faceplate panel should remain in place unless a power supply is in the power supply slot. Do not operate the Sensor without the faceplate panel in place. McAfee® Network Security Platform M-2750 Sensor Product Guide 17