Miele DAR 1230 Set 18 Operating instructions - Page 19

Cleaning and care WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:  Before cleaning or servicing the hood, disconnect it from the power supply, see "IMPORTANT SAFETY INSTRUCTIONS". Stainless steel housing General information The surfaces and control buttons are susceptible to scratching and chipping. Observe the following cleaning instructions.  Clean all surfaces and control buttons using warm water and liquid dish soap. Apply with a sponge cloth. Make sure that no water gets into the interior of the hood. Only use a damp cloth to clean the hood, especially in the control panel area. Special instructions for stainless steel surfaces  Stainless steel surfaces can also be cleaned using a non-abrasive stainless steel cleaner.  To prevent the surfaces from quickly becoming dirty again, we recommend treating them with a stainless steel care conditioner. Apply sparingly over the entire area using a soft cloth. Important for the controls Do not leave dirt and debris on the buttons for any length of time. Otherwise they may become discolored or damaged. Remove any dirt or debris immediately.  Observe the general cleaning instructions contained in this chapter. Do not use a stainless steel cleaner to clean the control buttons.  After cleaning, dry the surfaces with a soft cloth. Avoid the following: - Cleaners containing soda, acid or chloride, or cleaners containing solvents - Abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents. 19