Miele DGC 4086 XL Product Manual - Page 70
Technical Data 70, Electrical connection 70, CAUTION, Installer, Please leave these instructions
View all Miele DGC 4086 XL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Technical Data ,CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the rating label correspond with the household electrical supply. This data must correspond to prevent appliance damage. Only operate the appliance after it has been installed. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele's Technical Service Department. Installer: Please leave these instructions with the consumer. Power supply Installation, repairs and other work by unqualified persons could be dangerous. ^ Be sure your electrical supply matches the data plate. The appliance is equipped with a 5 ft. (1.5 m) flexible power cord encasing 3 wires ready for hardwiring to a 240 V, 20 A, 60 Hz grounded power supply. It must be connected to a dedicated line through the use of an approved junction box. A disconnection incorporated in the fixed wiring must be provided. There must be an all-pole contact gap of at least 3 mm in the isolator switch (including switch, fuses and relays). Black wire: connect to L1 (hot) Red wire: connect to L2 (hot) Green wire: connect to GND (ground) For further information, see the wiring diagram provided with the appliance. ,WARNING: THIS APPLIANCE MUST BE GROUNDED! 70