NEC EX341R Users Manual - Page 11

English Mount Flexible Arm This LCD monitor is designed for use with a flexible arm. 1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand. 2. Use the 4 screws removed from the stand or the specified screws to attach the arm to the monitor (Figure F.1). Caution: Use ONLY the screws (4 pcs) that were removed from the stand or the specified screws (Figure F.1) to avoid damage to the monitor or stand. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. TUEV GS mark). NOTE: Tighten all screws (recommended Fasten Force: 98 - 137N•cm). Spring washer Flat washer 12 mm Thickness of Bracket (Arm) 2.0~3.2 mm 100 mm 100 mm Weight of LCD assembly: 7.6 kg Figure F.1 Additional VESA Holes for Lower Monitor Head Position Additional 4 VESA holes are provided for those users needing a lower monitor head position than that is available from the monitor stand in shipping configuration. The monitor stand can be re-attached by using the 4 screws to the lower position VESA holes. NOTE: 1. The monitor head tilt function may experience impaired operation when attached to the lower position VESA holes. 2. The monitor head pivot function should not be used when attached to the lower position VESA holes. 4 Screws (M4) Additional 4 VESA English-9