NEC FZ110A Installation Guide - Page 5
Con jumper, settings, ATAPI, drive, needed, system.
UPC - 102645813929
View all NEC FZ110A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
5 Configure jumper settings on the Zip ATAPI drive as needed for your system. The Zip ATAPI drive ships ready to install as the second drive on the IDE connection ("Drive I (slave), not drive A:" configuration). If the Zip ATAPI drive will be the only drive connected to the IDE interface cable, change the jumper setting to the "Drive 0 (master), not drive A:". If the computer is a Cable Select system, use the "Cable Select, not drive A:" jumper setting. Jumper block Drive 0 (Master), not drive A: Drive 1 (Slave), not drive A: (Factory setting) Cable select, not drive A: 7 Drive 0 (Master), drive A. See NOTE. Drive 1 (Slave), drive A: Cable Select, drive A: 0 / 0 0 0 0 • • • • ■ NOTE: The Zip drive has "Drive 0 (Master), drive A", "Drive 1 (Slave), drive A', and "Cable Select, drive A" configuration for the extension of the future. These configurations may have to use in the future, but can not use now. ■ 3