NEC LCD1810 MultiSync LCD1810 Setup Sheet - Page 14
ALL RESET, Information
UPC - 050927216145
View all NEC LCD1810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Controls cont.ols ALL RESET MultiSync® LCD1810™ monitor only Selecting ALL RESET when D-SUB input is selected allows you to reset all OSM control settings for the D-SUB input back to the factory settings. Selecting ALL RESET when BNC input is selected allows you to reset all OSM control settings for the BNC input back to the factory settings. Individual settings can be reset by highlighting the control to be used and pressing the RESET button. MultiSync LCD2010™ monitor only Selecting ALL RESET allows you to reset all OSM control settings back to the factory settings. Individual settings can be reset by highlighting the control to be used and pressing the RESET button. Information Indicates the current display resolution, frequency setting and type of Sync signal the monitor is using. NOTE: Mode Change should only be used if a resolution is not recognized by the monitor. The user can change to the appropriate resolution by selecting the Mode information and selecting (increase or decrease) the corresponding option. NOTE: If the or button is pressed while TYPE is highlighted, then Sync Type is switched between Separate Sync and Sync On Green. 78133813.wpc 12 14 10/28/99, 3:22 PM