NEC LCD1810 MultiSync LCD1810 Setup Sheet - Page 5
Quick Start - power cable
UPC - 050927216145
View all NEC LCD1810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Quick Start To attach the MultiSync® LCD1810™ monitor to your system, follow these instructions: 1. Turn off the power to your computer. If you are using the supplied video signal cable, continue to step 2. If you are using a BNC cable (not included), please skip to Step 3. NOTE: BNC cables may be purchased at your local electronics store. 2. For the PC: Connect one end of the video signal cable to the back of the monitor (Figure A.1) and the other end to the connector of the display card in your system (Figure A.2). Tighten all screws. Proceed to Step 4. Connector Cover Figure A.1 3 78133813.wpc 5 Figure A.2 10/28/99, 3:21 PM
Quick Start
3
Figure A.1
Figure A.2
Connector
Cover
To attach the MultiSync
®
LCD
1810
™
monitor to your system, follow
these instructions:
1.
Turn off the power to your computer.
If you are using the supplied video signal cable, continue to step 2.
If you are using a BNC cable (not included), please skip to Step 3.
NOTE:
BNC cables may be purchased at your local electronics store.
2.
For the PC: Connect one end of the video signal cable to the back of the monitor
(Figure A.1)
and the other end to the connector of the display card in your system
(Figure A.2).
Tighten all screws. Proceed to Step 4.
78133813.wpc
10/28/99, 3:21 PM
5