NEC NC2402ML Installation Manual - Page 99
Remove the blocking panel, Mount the option board to the projector.
View all NEC NC2402ML manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Setting Up Your Projector 1 Remove the side panel. Side panel of the projector should be removed to mount the option board. For the procedure of removing the side panel, refer to "1-5-2. Removing and Mounting the Side Panel" (page 53). 2 Remove the blocking panel from slot. 1. Loosen the knurled screws (2 places) of slot until their rotations become idle ( ). Screws cannot be removed. 2. Remove the blocking panel ( ). Slot NOTE Carefully store the blocking panel and screws that you removed. 3 Mount the option board to the projector. 1. Insert the board by following the guide on either side of the slot. 2. While pushing up and holding the board, tighten up the knurled screws (2 places) until it fix. guide (left/right) 4 Mount the side panel to the projector. This completes the mounting of option board. Next, clear any tamper events. For details on how to clear tamper events, refer to "3-2. Recovering from Tamper Errors" (page 103). A setting to use option board is needed, after recovering from tamper error. For the procedure, refer to "2-8-1. Make the option board usable" (page 100). 99