NEC PX-42XM2A 42VP4/42XM2/50XM3/61XM2 - Page 17
Creating a video wall, Cable Management - model
View all NEC PX-42XM2A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Creating a video wall With buit-in matrix display capability, you can create a 2×2 or 3×3 video wall. • Connect signal cables and remote cables as shown below. Video signal RGB/DVD/HD signal BNC connector IN VIDEO Signal RCA phono plug VIDEO 3 VIDEO VIDEO 1 ( I N / OUT) VIDEO 2 BNC connector OUT VIDEO Signal RGB signal/ IN DVD/HD signal AUDIO 1 R L (MONO) Y DVD1 Remote IN control REMOTE OUT IN OUT Remote control Remote IN control REMOTE OUT IN RGB 1 (IN / OUT) VD Cb/Pb HD Y Cr/Pr B/ G/ R/ RGB2 / DVD2 / HD2 OUT RGB signal/ DVD/HD signal OUT Remote control Note: 1. The VIDEO1 and RGB1 terminals can be used for either INPUT or OUTPUT. When LOOP OUT is ON, do not connect an OUTPUT signal from another unit, that will place an extraordinary load on the other unit and may damage it. 2. LOOP OUT can not be turned ON while signals are input to RGB1 terminal. 3. LOOP OUT can be turned ON while signals are input to RGB1 terminal if the POWER is switched ON. Information • To loop signals out to another plasma display, set the LOOP OUT to ON. • To create a video wall, set the VIDEO WALL menu items properly. • To connect monitors, please use a 1~2m (3.3~6.6 feet) BNC cable (any commercially available cable). • If the image quality is poor, do not use the monitor's out terminal. Use a distribution amplifier (any commercially available distribution amplifier) to connect the split signals to the respective monitor INPUT terminals. • Being used as a video wall function, maximaly 4-screen is rough-standard with lower than 1024ן768, 60Hz signal. • A distribution amplifier is particularly recommended when using a 9-screen video wall. • From the second monitor onward, connections require a BNC-RCA conversion cable or connector, a mini D-Sub 15 pin cable-BNC (ן5) cable or a conversion connector. Cable Management Using the cable clamps provided with the plasma display, bundle at the back of the unit the signal and audio cables connected to the display. * The cable clamp will differ according to the model. Back of the unit mounting hooks/mounting holes To attach 1. 2. clamp To detach mounting hook To attach 1. 2. clamp cables To detach mounting hole cables 10