NaceCare ETB1120 ETB1120 Owners Manual - Page 10

Machine Set-Up ! ALWAYS ENSURE THAT THE BATTERY IS DISCONNECTED BEFORE MAKING ANY ADJUSTMENTS ! Fitting the brushes Featuring the Nulock brush system. The brush is simply pushed and twisted to lock, making fitting and removal a simple process. The Pad is retained using Numatic's own PadLoc system. (Ask your supplier for details) Only use manufacturer supplied brushes / pads. ETB 1120 requires a 20'' brush or pad Fit the brush /pad to the drive chuck, twist to lock the brush (Fig 14) / pad in place (Fig 15). Fig 14 Safety gloves are recommended for the changing of used brushes. Tipping the Brush Deck To tip the deck into the down position (Operating mode) Press in the brush deck locking bar (Fig 16) and rotate the brush deck (Fig 17). Fig 16 To change to brush deck up position, (Transit mode) simply lift the deck and the sprung loaded locking bar will active to hold the deck up. Fitting and lowering the Floor Tool The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement. Fig 15 Fig 17 Fig 18 Fit the floor tool and retain using the detent Pin (Fig 18). The lifting strap is held by a detent pin (Fig 19). Raise the floor tool for transit or lower for cleaning operation using the lifting handle fitted to the back of the machine (Fig 20). We are now ready to set the controls to suit the cleaning conditions. Before any settings can be applied, ensure the brush deck is lowered. Fig 19 Fig 20 Note: It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first. 10