NaceCare ETB1120 ETB1120 Owners Manual - Page 11

Machine Set-Up Filling the clean-water tank The ETB Range is equipped with a 11 gal clean-water tank allowing large areas to be cleaning in a single fill. To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap or hose pipe (Fig 21). The large cap can also be unscrewed for filling from a bucket or suitable container. Fill the clean water tank to a maximum of 11 gal, Fig 21 including cleaning chemicals if required. Follow chemical manufacturing guide lines. The clear Dump hose at the rear of the machine can be used to see the level of the clean water. 100% Note. Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris. ! WHEN HANDLING AND MIXING CHEMICALS. Always ensure that chemical manufacturers safety guidelines are followed. Only use chemicals recommended for use in auto scrubber-dryers. ! ! Important Do not operate machine unless the Operator Manual has been read and fully understood. ! Pre-cleaning advice. Before performing the cleaning operation, place out appropriate warning signs and sweep or dust-mop the floor (Fig 22). Numatic part (629044) Wet Floor sign (available if required) 11 Fig 22