NaceCare HGB817 Owners Instructions - Page 7
Fitting the Hose Guide, Filling the Clean Water Tank
View all NaceCare HGB817 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Machine Set-up Guide Fitting the Hose Guide The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation. NOTE: DO NOT push the vacuum hose onto the floor tool with the floor tool in the raised position. Filling the Clean Water Tank A B Refit vacuum hose to the Floor tool when finished. C To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap or hose pipe. (Fig.C). The large cap can also be used for filling from a bucket or suitable container. (Fig.A & B). Fill the clean-water tank to MAX line indication on tank, including cleaning chemicals if required. Follow chemical manufacturing guide lines. The clear dump hose at the rear of the machine can be used to see the level of the clean-water. (Fig.D). NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris. Control of Substances Hazardous to Health (COSHH) For best results use a non-foaming type of chemical, dilute to the manufacturers specification. For further guidance on hazardous substances refer to health and safety instructions online. D T 01460 68600 7