NaceCare TGB2228 Owners Instructions - Page 11

Regular Maintenance ! ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY. REMOVE THE KEY PRIOR TO ANY MAINTENANCE OPERATION. ! After use, empty waste water tank A using emptying hose and flush out with clean water. A B Next remove floor tool vacuum hose and flush out with clean water. C Next empty clean water tank, using emptying hose and again flush out with clean water. B C Whilst pressing in the top tank hood toggles, remove the hood. The hood also has a sealing-rubber which should be examined at every clean-down. Rinse using clean water, avoiding the vac filter. Located in your waste water (top) tank is a full tank switch, this stops the vacuum from working once the waste water reaches its maximum limit. Sometimes the switch gets clogged and blocked, clean to ensure correct operation. Also please ensure float pad is clean and in correct position. IMPORTANT Remove vac filter and clean if required (keep dry). Never use the machine without the recommended filter as it may cause damage to the machine. Remove debris basket filter and rinse using clean water, and refit. IMPORTANT If the debris basket is allowed to become clogged, vacuum performance can deteriorate. Located under the top tank at the front of the machine is a clean water filter. Note: Make sure the top tank is empty before lifting. T 01460 68600 11