NaceCare TGB2228 Owners Instructions - Page 13

Machine Charging ! Always ensure that the machine is switched off prior to charging. ! The battery meter displays the charge level of the batteries; when fully charged, all meter lights are illuminated. 1 As the machine is used and the batteries are discharged, the meter lights will go out from right to left. If the battery-charge level is allowed to discharge to the point that only the red light remains illuminated, the operator must consider charging the machine. 2 When the machine is getting close to empty the second light from the end starts to flash, the operator should then take the machine to a suitable charging point. 3 The large capacity gel batteries are sealed for life and are totally maintenance free. The on-board charger automatically monitors the charging process and will switch off when the batteries are fully charged. Insert the charging lead required for your country into the charging point. The machine charging point is located to the rear of the machine under the control panel. Connect to a suitable power supply. Once mains power is connected the red charging indicator will illuminate. To ensure a full charge, the machine should be left for a period of 8 - 10 hrs. Once fully charged, disconnect the charging lead from both the power supply and the machine. Battery Care ! To ensure your machine remains at its maximum efficiency and prolong your battery life, please follow the simple steps below: ! UNDER NORMAL DAILY USAGE: Re-charge the machine FULLY after each use regardless of machine operation time. Do not leave the machine in a discharged state. T 01460 68600 13