NaceCare TGB2228 Owners Instructions - Page 6

Machine Set-up Guide ! ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF BEFORE MAKING ANY ADJUSTMENTS ! Fitting the Brush / Pad. 2 x 370mm Brush or a 2 x 360mm Pad on the TGB 8572. Featuring the Nulock brush system. The brush is simply pushed and twisted to lock, making fitting and removal a simple process. Slide the brush / pad under the brush deck. Fit the brush / pad onto the Nulock drive chuck, twist to lock the brush / pad in place. Note: Safety gloves are recommended for the changing of used brushes. Brush Deck Pitch Adjustment If the machine has a tendency to pull to either side while cleaning forwards, this can be compensated for by turning the brush deck pitch adjustment knob. LH Bias: If the machine pulls to the right, turn the knob clockwise to apply left hand bias to the brush deck. RH Bias: If the machine pulls to the left, turn the knob counterclockwise to apply right hand bias to the brush deck. L Turning the knob clockwise will make the machine pull more to the left. R Turning the knob counter-clockwise will make the machine pull more to the right + - Fitting the Floor Tool The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the floor tool gets snagged, whilst in transit. Fit the floor tool and retain using the detent pin. Push vacuum hose onto the floor tool; ensure a tight fit. NOTE: DO NOT push the vacuum hose onto the floor tool with the floor tool in the raised position. Raise the floor tool for transit or lower for cleaning operation using the lifting handle fitted to the back of the machine. For fitting the floor tool blades (See P12). T 01460 68600 6