Home » Netgear Manuals » Networking » Netgear EA201C » Manual Viewer

Netgear EA201C Installation Guide - Page 15

click on the X in the right hand corner to close any open windows and return to - driver

UPC - 606449001945

Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

4. If there is a problem with the installation of the driver, an exclamation point appears next to "NETGEAR EA201 Ethernet Card." If there is an exclamation point, doubleclick on "NETGEAR EA201 Ethernet Card." The "Properties" window opens, and a message regarding the status of the device is displayed. Continue to click on "OK" or click on the "X" in the right hand corner to close any open windows and return to the Windows 95 desktop. Restart your PC by selecting "Shut Down" from the Windows 95 Startup menu and then selecting "Restart the computer." Model EA201 Network Card Installation Guide

Section	Page
The instructions included in this guide are for installing the Model EA201 Network Card when usin...	2
These three easy steps provide information for installing your Model EA201 Network Card:	2
1. Verify Package Contents 2. Install the Network Card 3. Connect the Network Cables	2
Unpack the contents of the package and make sure that you have everything.	3
The instructions given in this guide are for using the NETGEAR™ Model EA201 Network Card in a PC ...	3
You must have a PC with:	3
1. Turn the power off and unplug the power cord from your computer.	4
2. Remove the PC cover.	4
3. Choose an available ISA slot (ISA slots are the longer slots) and remove the corresponding bac...	4
4. Insert the network card into the ISA expansion slot.	4
5. Fasten the network card to the rear of the computer chassis by tightening the screw that is on...	4
6. Replace the PC cover and reconnect the power cord to the PC.	4
Using the UTP cable that is supplied, connect any port on the hub to the port on the network card.	5
This guide provides you with instructions for installing the Windows 95 Network Driver. All versi...	7
Before you proceed with the installation steps, decide on a name for your network and for each PC...	7
1. Turn on power to the computer and start Windows 95.	7
The new hardware is found and the driver is automatically loaded.	7
2.	8
3.	8
4.	9
5. Click on “OK.”	9
6.	10
7.	10
8.	11
9.	11
10. Proceed to “Verify Installation.”	11
1.	12
2.	13
3.	14