Home » Netgear Manuals » Networking » Netgear EA201C » Manual Viewer

Netgear EA201C Installation Guide - Page 3

Verify Package Contents - isa network card

UPC - 606449001945

Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Verify Package Contents Unpack the contents of the package and make sure that you have everything. Model EA201 Network Card Drivers and Diagnostics Disk Category 5 10/100 Mbps UTP cable (provided with Model EA201C Network Card) Installation guide, Warranty & Owner Registration Card 8034FA Verify PC Requirements The instructions given in this guide are for using the NETGEAR™ Model EA201 Network Card in a PC that has a Microsoft® Windows 95 or Windows for Workgroups (v.3.11) operating system. You must have a PC with: • Windows 95 or Windows for Workgroups (version 3.11) • An available ISA expansion slot Model EA201 Network Card Installation Guide

Section	Page
The instructions included in this guide are for installing the Model EA201 Network Card when usin...	2
These three easy steps provide information for installing your Model EA201 Network Card:	2
1. Verify Package Contents 2. Install the Network Card 3. Connect the Network Cables	2
Unpack the contents of the package and make sure that you have everything.	3
The instructions given in this guide are for using the NETGEAR™ Model EA201 Network Card in a PC ...	3
You must have a PC with:	3
1. Turn the power off and unplug the power cord from your computer.	4
2. Remove the PC cover.	4
3. Choose an available ISA slot (ISA slots are the longer slots) and remove the corresponding bac...	4
4. Insert the network card into the ISA expansion slot.	4
5. Fasten the network card to the rear of the computer chassis by tightening the screw that is on...	4
6. Replace the PC cover and reconnect the power cord to the PC.	4
Using the UTP cable that is supplied, connect any port on the hub to the port on the network card.	5
This guide provides you with instructions for installing the Windows 95 Network Driver. All versi...	7
Before you proceed with the installation steps, decide on a name for your network and for each PC...	7
1. Turn on power to the computer and start Windows 95.	7
The new hardware is found and the driver is automatically loaded.	7
2.	8
3.	8
4.	9
5. Click on “OK.”	9
6.	10
7.	10
8.	11
9.	11
10. Proceed to “Verify Installation.”	11
1.	12
2.	13
3.	14