Netgear FSM726E FSM726E Hardware Installation Guide - Page 19
Installation, Selecting a Location
UPC - 606449063820
View all Netgear FSM726E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Managed Layer 2 Switch with 2 Gigabit Ethernet Ports FSM726E Hardware Installation Guide Installation Install the equipment in the following sequence, as presented in this chapter: 1. Select a Location. See "Selecting a Location. 2. Install the Switch. See "Installing the Switch" on page 2-4. 3. Check the installation. See "Checking the Installation" on page 2-5 4. Apply power, and check the LEDs. See "Connecting to Power and Checking the LEDs" on page 2-5. Selecting a Location The switch can be mounted in a standard 19-inch (48.26-centimeter) rack, wall mounted, or left freestanding (placed on a tabletop). The site where you install the switch can affect its performance. Before installing the switch or switches, make sure that the chosen installation location meets the following site requirements. Table 2-1. Site Requirements for Switch Location Requirements Mounting Access Power source Environment Temperature Operating humidity Ventilation • Desktop installations. Provide a flat table or shelf surface. • Rack mounted installations. Use a 19-inch (48.3-centimeter) EIA standard equipment rack that is grounded and physically secure. Use the rack mounting kit supplied with your switch. Put the switch in a position that lets you access the front panel RJ-45 ports, view the front panel LEDs, and access the rear-panel power connector. Provide a power source within 6 feet (1.8 meters) of the installation location. Power specifications for the switch are shown in Appendix A, "Factory Default Settings and Technical Specifications. Be sure that the AC outlet is not controlled by a wall switch, which can accidentally turn off power to the outlet and the switch. Install the switch in a site free from strong electromagnetic field generators (such as motors), vibration, dust, and direct exposure to sunlight. The ambient switch operating temperature range is 23° to 122°F (-5° to 50°C). Keep the switch away from heat sources such as direct sunlight, warm-air exhausts, hot-air vents, and heaters. Install the switch in a dry area with a maximum relative humidity of 90%, noncondensing. Do not restrict airflow by covering or obstructing air inlets on the sides of the switch. Keep at least 2 inches (5.08 centimeters) free on all sides for cooling. Be sure that there is adequate airflow in the room or wiring closet where you will install the switch. Hardware Installation 2-3 v1.0, November 2008