Netgear GS752TS GS7xxTS-TPS Software Admin Manual - Page 145
IGMP Snooping Querier VLAN Configuration, Snooping Querier Address
View all Netgear GS752TS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
GS728TS, GS728TPS, GS752TS, and GS752TPS Gigabit Smart Switches To configure IGMP Snooping Querier settings: 1. From the Querier Admin Mode field, enable or disable the administrative mode for IGMP Snooping Querier. 2. In the Snooping Querier Address field, specify the IP address to be used as source address in periodic IGMP queries. This address is used when no address is configured on the VLAN on which the query is being sent. 3. In the IGMP Version field, specify the IGMP protocol version used in periodic IGMP queries. The supported IGMP versions are 1 and 2. The default value is 2. 4. In the Query Interval field, specify the time interval in seconds between periodic queries sent by the snooping querier. The Query Interval must be a value in the range of 1-1800 seconds. The default value is 60. 5. In the Querier Expiry Interval field, specify the time interval in seconds after which the last querier information is removed. The Querier Expiry Interval must be a value in the range of 60-300 seconds. The default value is 125. 6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 7. Click Apply to apply the new settings to the switch. Configuration changes take effect immediately 8. Click Refresh to update the page with the latest information from the switch. IGMP Snooping Querier VLAN Configuration Use this page to configure IGMP queriers for use with VLANs on the network. To access this page, click Switching> Multicast > IGMP Snooping Querier > Querier VLAN Configuration. 145