Netgear GSM7212P GSM5212P/GSM7212P/GSM7212F/GSM7224P Administration Manual - Page 12

ProSafe Managed Switch Assign Ports to VLAN2 This sequence shows how to assign ports to VLAN2, and to specify that frames will always be transmitted tagged from all member ports and that untagged frames will be rejected on receipt. CLI: Assign Ports to VLAN2 (Netgear Switch) #config (Netgear Switch) (Config)#interface range 1/0/1-1/0/2 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 2 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan acceptframe vlanonly (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 2 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit (Netgear Switch) (Config)#vlan port tagging all 2 (Netgear Switch) (Config)# Web Interface: Assign Ports to VLAN2 1. Assign ports to VLAN2. a. Select Switching > VLAN > Advanced > VLAN Membership. A screen similar to the following displays. b. In the VLAN ID list, select 2. c. Click Unit 1. The ports display. d. Click the gray boxes under ports 1 and 2 until T displays. The T specifies that the egress packet is tagged for the ports. e. Click Apply to save the settings. 2. Specify that only tagged frames will be accepted on ports 1/0/1 and 1/0/2. 12 | Chapter 2. VLANs