Netgear WAG302 WAG302v1 Reference Manual - Page 37
Adjust for Daylight Saving Time, Secondary DNS Servers. - default ip address
![]() |
View all Netgear WAG302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
ProSafe Dual Band Wireless Access Point WAG302 Reference Manual (802.11a/g) - DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless access point will get its IP address, subnet mask and default gateway settings automatically from the DHCP server on your network when you connect the WAG302 to your LAN. - IP Address. Enter the IP Address of your wireless access point.The default IP address is 192.168.0.230. To change it, enter an unused IP address from the address range used on your LAN; or enable DHCP. - IP Subnet Mask. The Access Point will automatically calculate the subnet mask based on the IP address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the subnet mask. - Default Gateway. Enter the IP address of the gateway for your LAN. For more complex networks, enter the address of the router for the network segment to which the wireless access point is connected. The default is 0.0.0.0. - Primary DNS Servers. The WAG302 will use this IP address as the primary Domain Name Server used by stations on your LAN. The default is 0.0.0.0. - Secondary DNS Servers. The WAG302 will use this IP address as the secondary Domain Name Server used by stations on your LAN. The default is 0.0.0.0. 5. Spanning Tree Protocol. Enable or disable spanning tree protocol. Spanning tree protocol provides network traffic optimization in settings with multiple WAG302 Wireless Access Points. The default is Enabled. 6. Enable 802.1Q VLAN. If enabled, each Security Profile will be associated with the default VLAN for WAG302. (Useful primarily if the hubs/switches on your LAN support the VLAN 802.1Q standard.) The default is Disabled. 7. From the pull-down menu, select the local Time Zone for your wireless access point from a list of all available time zones. The default is GMT. 8. Check the Adjust for Daylight Saving Time if your location uses daylight saving. The default is no adjustment. Note: You must have an Internet connection to get the current time. 9. Click Apply to save your Basic IP settings. Basic Installation and Configuration v2.0, May 2006 2-13
![](/manual_guide/products/netgear-wag302-wag302v1-reference-manual-31a4291/37.png)