Netgear XSM4348CS Hardware Installation Guide - Page 54
Install two half-width switches in a rack
View all Netgear XSM4348CS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Install two half-width switches in a rack To install two half-width switches in a single rack space, you need the 19-inch rack-mount kit, which includes inside and outside middle mounts, supplied with the switch. The figures in the following procedure show two M4300-24X switches. However, you can install any two half-width models in the same manner. For example, you can also install two M4300-8X8F switches or one M4300-8X8F switch and one M4300-12X12F switch in a single rack space. To install two single half-width switches in a single rack space: 1. On the switch that will be on the left side of the rack space, do the following: a. On the right side of the switch, attach the inside middle mounts by inserting the screws provided in the rack-mount kit through the mounts and into the mounting holes in the switch. Position the male mounts on the same side of the switch and the female mounts of the switch on the other side. b. Tighten the screws with a No. 2 Phillips screwdriver to secure each middle mount to the right side of the switch. 2. On the switch that will be on the right side of the rack space, do the following: a. On the left side of the switch, attach the outside middle mounts by inserting the screws provided in the rack-mount kit through the mount and into the mounting holes in the switch. For this switch too, position the male mounts on the same side of the switch and the female mounts of the switch on the other side. b. Tighten the screws with a No. 2 Phillips screwdriver to secure each middle mount to the right side of the switch. Installation 54 Hardware Installation Guide