NordicTrack 1300 Elliptical English Manual - Page 7

3. Tip: Do not pinch the Wire Harnesses (97, 54). Start all screws before tightening any of 3 them. While a second person holds the Upright (6) near the Frame (1), connect the Upper Wire Harness (97) to the Lower Wire Harness (54). Attach the Upright (6) to the Frame (1) with five 5/16" x 1" Patch Screws (81) and five 5/16" Split Washers (105). 6 81 105 81 Do not pinch the Wire Harnesses (97, 54) during this step 97 54 1 105 81 4. Apply a generous amount of the included grease to the Pivot Axle (33) and to two 5/8" Wave Washers (102). Tip: Do not pinch and damage the Upper Wire Harness (97). Insert the Pivot Axle (33) through the Upright (6). Then, slide a 5/8" Wave Washer (102) onto each end of the Pivot Axle. Slide an Upper Body Arm (12) onto the left side of the Pivot Axle (33). Attach the Upper Body Arm with a 5/16" x 1" Patch Screw (81), a Large Axle Cover (94), and a 5/16" Washer (104). Attach the other Upper Body Arm (12) in the same way. 4 104 97 81 94 102 12 6 Do not pinch the Upper Wire Harness (97) during this step Grease 33 102 104 94 81 12 7