NordicTrack C 9.5 Instruction Manual - Page 34

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Regular maintenance is important for optimal performance and to reduce wear. Inspect and properly tighten all parts each time the elliptical is used. Replace any worn parts immediately. Note: For clarity, the left shield and the left disc ring are shown removed in the drawing below. Locate the Reed Switch (38). Turn the Pulley (19) until a Magnet (43) is aligned with the Reed Switch. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage 19 to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you hold the handgrip heart rate monitor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 23. INCLINE SYSTEM TROUBLESHOOTING 38 43 101 If the ramp does not move to the correct incline level, see step 4 on page 31 and calibrate the incline system. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first unplug the power cord. Slightly loosen the indicated M4 x 16mm Screw (101). Slide the Reed Switch (38) slightly closer to or away from the Magnet (43), and then retighten the Screw. Then, plug in the power cord, and rock the Pulley (19) forward and backward just enough that the Magnet passes the Reed Switch repeatedly. Using a standard screwdriver, pry off the left Disc (71). 71 Repeat these actions until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the left disc. Then, plug in the power cord. 34