NordicTrack Freestride Trainer Fs9i English Manual - Page 28

MAINTENANCE AND TROUBLESHOOTING MAINTENANCE Inspect and tighten all parts of the elliptical regularly. Replace any worn parts immediately. To clean the elliptical, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you use the chest heart rate monitor, see TROUBLESHOOTING on page 12. If it is difficult for you to touch the correct buttons on the screen, the screen may not be properly calibrated. To calibrate the screen, see step 5 on page 24. HOW TO LEVEL THE ELLIPTICAL If the elliptical rocks slightly on your floor during use, see HOW TO LEVEL THE ELLIPTICAL on page 14. INCLINE SYSTEM TROUBLESHOOTING If the frame does not move to the correct incline level, see step 4 on page 24 and calibrate the incline system. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first unplug the power cord. Next, use a standard (flat) screwdriver and pry the Outer Disc (20) off the Right 23 Outer Shield (23). 20 Locate the Reed Switch (56). Turn the Pulley (73) until a Magnet (137) is aligned with the Reed Switch. 98 56 54 137 126 73 Next, remove the two M4 x 16mm Screws (98), and then remove the Reed Switch Bracket (54). Then, loosen, but do not remove, the two M4 x 10mm Clamp Screws (126). 28