Oki C911dn C911dn/C931dn/C941dn Basic User's Guide - Page 137
Network interface specifications, Signal, Function
![]() |
View all Oki C911dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Specifications Network interface specifications zzBasic specifications 1 Network protocols Before use zzFor TCP/IP zzFor EtherTalk zzConnectors 1000BASE-T / 100 BASE-TX / 10 BASE-T (Auto switching and simultaneous use are not possible) 2 Note zz The default factory setting is to disable 1000BASE-T. If using with 1000BASE-T, use the control panel to make the following settings. Set to [Administrator menu]> [Enter password> [Network Setup]> Gigabit Network]> [Enable]. Setting Up zzCables Unshielded twist pair cable with EJ-45 connector (category 5e or later) zzConnector pin array 3 Printing zzInterface signals 4 Basic Device Operations Pin Signal No. name 1 TRD+(0) 2 TRD-(0) 3 TRD+(1) 4 TRD+(2) 5 TRD-(2) 6 TRD-(1) 7 TRD+(3) 8 TRD-(3) Function Data 0 sending and receiving (+) Data 0 sending and receiving (-) Data 1 sending and receiving (+) Data 2 sending and receiving (+) Data 2 sending and receiving (-) Data 1 sending and receiving (-) Data 3 sending and receiving (+) Data 3 sending and receiving (-) Appendix Index - 137 -
![](/manual_guide/products/oki-data-c911dn-c911dnc931dnc941dn-basic-users-guide-f638c3b/137.png)