Oki ML490 Maintenance Manual - Page 63
PC Connector
View all Oki ML490 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
3.3.6 PC Connector (1) Remove the printhead (see 3.3.1). (2) Remove the upper cover (see 3.3.4 (1) - (5)). (3) Remove the gear case Assy (see 3.3.5). (4) Remove the PC connector 1 from the space motor Assy 2. (5) To install, follow the removal steps in the reverse order. Note on installation: (1) Do not touch the space motor 2 or terminals of PC connector 1. Also, take care to avoid dust or foreign matters. (2) After installation, check and adjust the gap between platen and printhead (see 4-1). (3) Make sure that there is not any dust or oil on the connector contact section A. If it is found, wipe it off by alcohol. 1 2 (rear side) A 42114101 Rev.1 63 /
42114101
Rev.1
63 /
3.3.6
PC Connector
(1)
Remove the printhead (see 3.3.1).
(2)
Remove the upper cover (see 3.3.4 (1) – (5)).
(3)
Remove the gear case Assy (see 3.3.5).
(4)
Remove the PC connector
1
from the space motor Assy
2
.
(5)
To install, follow the removal steps in the reverse order.
Note on installation:
(1)
Do not touch the space motor
2
or terminals of PC connector
1
.
Also, take care
to avoid dust or foreign matters.
(2)
After installation, check and adjust the gap between platen and printhead (see 4-1).
(3)
Make sure that there is not any dust or oil on the connector contact section A. If it
is found, wipe it off by alcohol.
1
2
(rear side)
A