Olympus E10 E-10 Instructions (English) - Page 25
Inserting the lithium battery pack CR-V3 - power switch
View all Olympus E10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Inserting the lithium battery pack (CR-V3) 1 Two lithium battery packs are required. Caution The lithium battery pack CR-V3 cannot be recharged. Power switch OFF ON Power is OFF. OFF ON Power is ON. 1 1 Make sure the white line on the power switch is at the OFF position. If the power switch is set to ON, move it to the OFF position. 2 Make sure that the card access lamp is off. If the card access lamp is blinking, wait for it to go off. 3 2 Card access lamp Raise the battery compartment knob and turn it to the open position in the direction of the arrow as shown in the illustration. Battery compartment knob 3 Caution If you remove the battery case with the camera power on, the current mode and time will be reset. The picture just taken may not be stored on the card, and images already stored on the card could be damaged. Please make sure that the power switch is set to OFF. OFF ON Power switch 23