Olympus LS-7 LS-7 Detailed Instructions (English) - Page 93
Troubleshooting
UPC - 050332178267
View all Olympus LS-7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Troubleshooting Symptom Nothing appears on the display Probable cause Action The batteries are not loaded properly. Verify that the batteries' polarities = and - are correct (☞ P.15). Battery power is getting low. Charge the batteries or replace with new batteries (☞ P.15, P.17). The power is off. Turn the power on (☞ P.20). Battery power is getting low. Charge the batteries or replace with new batteries (☞ P.15, P.17). Won't start The power is off. Turn the power on (☞ P.20). The recorder is in HOLD mode. Release the recorder from HOLD (☞ P.21). Unable to record Low remaining memory. The maximum number of files has been reached. Erase unnecessary files (☞ P.45). Change to any other folder (☞ P.27 to P.29). Unable to record An external microphone supported by Set [Plug-inPower] to [On] when an through an external plug-in power is connected but [Plug- external microphone supported by microphone No playback sound in Power] is set to [Off]. The earphone is connected. plug-in power is connected (☞ P.56). Unplug the earphones to use the 6 internal speaker. heard The volume level is set to [00]. Adjust the volume level (☞ P.37). Recording level too low Recording level too high The recording level has not been adjusted. The microphone sensitivity is too low. This could potentially be because the output level for the connected external devices are too low. The recording level has not been adjusted. This could potentially be because the recording level and output level for connected external devices are too high. Adjust the recording level and then try recording once more (☞ P.51). Set [Mic Sense] to [High] or [Middle] (☞ P.50). Adjust the output level for the connected devices. Adjust the recording level and then try recording once more (☞ P.51). If you cannot record clearly even after adjusting the recording level, then adjust the output level for the connected devices (☞ P.51). Troubleshooting EN 93