Onkyo CS-V645 DR-645 Owner Manual - Page 26

OSD (ON SCREEN DISPLAY) LANGUAGE Select the desired language for on screen menus of the unit from the following: (European and North American) ` ENGLISH ` FRANÇAIS ` DEUTSCH ` ITALIANO ` ESPAÑOL (Hong Kong) ` English ` Chinesetrad SCREEN SAVER ` ON: The screen saver starts up if nothing is played back and no operations are performed for 4 minutes. ` OFF: The screen saver does not start up. DIVX CODE (excluding North American models) ` OK: Display the DivX® registration code. AUDIO SETUP DIGITAL AUDIO SETUP ■ DIGITAL OUTPUT ` OFF: Select this when you do not use the COAXIAL DIGITAL AUDIO OUT jack. No signal is output from this jack. ` ALL: Select this when the unit is connected to an audio component equipped with a built-in Dolby Digital decoder via the COAXIAL DIGITAL AUDIO OUT jack. `PCM only: Select this when the unit is connected to an audio component such as amplifier/receiver, CD recorder or MD deck via the COAXIAL DIGITAL AUDIO OUT jack. DOLBY DIGITAL SETUP ■ DUAL MONO ` STEREO: Left channel is output from the left speaker, and right channel is output from the right speaker. ` L-MONO: Left channel is output from the front left and right speakers. ` R-MONO: Right channel is output from the front left and right speakers. En 26 3D PROCESSING ■ REVERB MODE This setting provides following sound effects: ` OFF ` CONCERT `LIVING ROOM ` HALL ` BATHROOM ` CAVE ` ARENA ` CHURCH • This function is effective only when playing back a DVD disc recorded with Dolby Digital. This control has no effect on other discs. • The overall effect of this setting depends on the disc being played, the amplifier, and the speakers used for playback. NIGHT MODE ` ON: Applies dynamic range control to Dolby Digital material, reducing the volume of loud sounds, and increasing the volume of quiet ones. This is useful for spoken word material, and nighttime listening etc. ` OFF: Turns off the audio dynamic compression. • This function is effective only when playing back a DVD disc recorded with Dolby Digital. This control has no effect on other discs. • The overall effect of this setting depends on the disc being played, the amplifier, and the speakers used for playback. AUDIO SYNC This setting can cause delays in the sound signal in 10 ms increments ranging from 0 ms to 200 ms (only for digital signals recorded on a disc or stored in a USB drive; unavailable for analog signals coming from LINE 1 or 2). Depending on the TV, it may take approximately 100 ms (0.1 sec.) for an image to appear after video signals are input, causing the image to appear after the sound coming from the unit is heard. • If this happens or audio and video synchronization creates a less than optimal viewing experience, adjust the delay using F (decrease) or S (increase).