Onkyo DX-R700 User Manual English - Page 20

Digital recording/Analog recording q MULTI JOG w INPUT STANDBY/ON STANDBY POWER ON OFF MEMORY CLEAR REPEAT FINALIZE DUAL DIGITAL INPUT DISPLAY MULTI JOG INPUT EDIT/ NO PUSH TO ENTER YES REC PAUSE STOP PLAY PHONES PHONES LEVEL MIN MAX AUDIO CD RECORDER DX-R700 STANDBY/ ON OPEN / CLOSE RANDOM MEMORY REPEAT 1 GHI 4 PQRS 7 >10 ABC 2 DEF 3 NAME J K L 5 MNO SCROLL 6 TUV 8 WXYZ CLEAR 9 DISPLAY ENTER 10/0 EDIT/NO oREC sPLAY oREC REC s You can perform digital recording to record the signal input to the digital input terminals or analog recording to record the signal input to the analog input terminals. The recording level can be adjusted manually. Types of digital source that can be recorded The DX-R700 contains an internal sampling rate converter, and therefore can record digital signals of the sampling rates given below. • 44.1 kHz (CDs, etc.) • 32 kHz (DAT, satellite broadcasts, etc.) • 48 kHz (DAT, satellite broadcasts, etc.) Note: When performing a digital recording from HDCDs, DTS CDs, and the like, be sure to set the recording level to 0 dB (see page 21). Preparation • Turn on the DX-R700 (see page 16). • Place a recordable CD-R or CD-RW in the DXR700 (see page 17). • Verify that the input dial and recording selection button of the amplifier are set to the position of the recording source. 1 Repeatedly press the INPUT button until "Digital In 1", "Digital In 2" or "Analog In" appears. INPUT or or Proceed to step 3 if you do not wish to adjust the recording level Note: Verify to which digital input the optical digital cable is connected. 2 Start playback of the recording source. 3 Press the o REC button. The level sync function is set to On (see page 26). "Rec setup" appears in the display followed by the time display (the recording standby state). DX-R700 RC-448C REC REC Proceed to step 6 if you do not wish to adjust the recording level. Note: When you select the digital input but the digital cable is not connected to the DX-R700, "D.InUnlock" will appear. 20