Onkyo DX-R700 User Manual English - Page 22

Synchronous recording by input signal detection (Signal synchronous recording) STANDBY/ON STANDBY POWER ON OFF MEMORY CLEAR REPEAT FINALIZE oREC DUAL DIGITAL INPUT DISPLAY MULTI JOG INPUT EDIT/ NO PUSH TO ENTER YES REC PAUSE STOP PLAY PHONES PHONES LEVEL MIN MAX AUDIO CD RECORDER DX-R700 INPUT STANDBY/ ON OPEN / CLOSE RANDOM MEMORY REPEAT 1 GHI 4 PQRS 7 >10 ABC 2 DEF 3 NAME J K L 5 MNO SCROLL 6 TUV 8 WXYZ CLEAR 9 DISPLAY ENTER 10/0 oREC REC This method allows you to start recording in synchronization with the input signals from the Onkyo products that are not equipped with an z connector or other manufacturer's products. When recording with the Onkyo products equipped with an z connector, refer to "Synchronous recording" on page 24. 1 Repeatedly press the INPUT button and select the desired input signal. Select "Digital In 1," "Digital In 2," or "Analog In" for the input source. INPUT Notes: Note the following when using synchronous recording for digital input sources. • Sources other than CDs, MDs, DATs, and DCCs cannot be recorded. • DATs and DCCs cannot be recorded if no start ID is present before audio contents. • Synchronous recording uses a sub-code signal that is contained in the digital output from most player components, and therefore there may be some CD players, MD recorders, or the like where digital synchronous recording is impossible. Preparation • Turn on the DX-R700 (see page 16). • Place a recordable CD-R or CD-RW in the DXR700 (see page 17). • Verify that the input dial and recording selection button of the amplifier are set to the position of the recording source. Proceed to step 3 if you do not wish to adjust the recording level. 2 Start playback of the recording source. 3 Press the o REC button. "Rec Setup" appears in the display followed by the time display. DX-R700 REC RC-448C REC Proceed to step 6 if you do not wish to adjust the recording level. 22