Onkyo HT-RC470 Owner Manual - Page 46
Using the Audio Settings of Quick Setup, En-46
View all Onkyo HT-RC470 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Note *1 • The video preview is not displayed when: - HDMI IN 5/6/7 is the current HDMI input source, or - No signal is present on the current input source. • The video of the currently-selected input is displayed on the main screen, not on a preview thumbnail. *2 "Dynamic EQ" and "Dynamic Volume" cannot be selected when any of the THX listening modes is selected, with "Loudness Plus" set to "On" or "Preserve THX Settings" set to "Yes" (➔ page 54). *3 When the "Monitor Out" setting is set to "Sub", "Video" cannot be selected (➔ page 50). *4 Only when you have selected "Custom" in the "Picture Mode" (➔ page 59), pressing ENTER allows you to adjust the following items via the Quick Setup: "Brightness", "Contrast", "Hue" and "Saturation". Press RETURN to return to the "Picture Mode" setting. *5 Depending on the input source and listening mode, not all channels shown here output the sound. *6 • This setting is not available in either of the following cases: - The "Audio TV Out" setting is set to "On" (➔ page 64). - "HDMI Control(RIHD)" is set to "On" (➔ page 63) and you're listening through your TV speakers. Using the Audio Settings of Quick Setup You can change various audio settings from the Quick Setup (➔ page 45). Note • These settings are not available in either of the following cases: - The "Audio TV Out" setting is set to "On" (➔ page 64). - "HDMI Control(RIHD)" is set to "On" (➔ page 63) and you're listening through your TV speakers. Tone Control ■ Bass ` -10dB to 0dB to +10dB in 2 dB steps You can boost or cut low-frequency sounds output from the front speakers. ■ Treble ` -10dB to 0dB to +10dB in 2 dB steps You can boost or cut high-frequency sounds output from the front speakers. You can adjust the bass and treble for the front speakers, except when the Direct or THX listening mode is selected. Speaker Levels Advanced Operations ■ Subwoofer Level `-15dB to 0dB to +12dB in 1 dB steps ■ Center Level `-12dB to 0dB to +12dB in 1 dB steps You can adjust the volume of each speaker while listening to an input source. These temporary adjustments are cancelled when the AV receiver is set to standby. To save the setting you made here, go to "Level Calibration" (➔ page 53) before setting the AV receiver to standby. Note • You cannot use these function while the AV receiver is muted. • These settings cannot be used while a pair of headphones is connected. • Speakers that are set to "No" or "None" in "Speaker Configuration" (➔ page 52) cannot be adjusted. Operating on the AV receiver 1 Press TONE repeatedly to select either "Bass" or "Treble". 2 Use - and + to adjust. En-46