Onkyo HT-RC470 Owner Manual - Page 69

Controlling Multi Zone Components ■ Operating on the AV receiver Input selector buttons ZONE 2 ZONE 3 MASTER VOLUME RECEIVER ZONE2 ZONE3 INPUT SELECTOR MUTING VOLR/X
Advanced Operations If your Zone 2 speakers are connected to a receiver or integrated amplifier in Zone 2, use its volume control to adjust the volume. Muting Zone 2 ■ Operating on the remote controller 1 Press ZONE2 followed by MUTING. ON/STANDBY Tip • The Whole House Mode function shares the input source of main room with Multi Zone (➔ page 44). 1 To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds. Zone 2/3 turns on, the Z2 or Z3 indicator lights on the AV receiver's display. To select the same source as the main room's, press ZONE 2 or ZONE 3 twice. "Z2 Sel: Source" or "Z3 Sel: Source" appears on the AV receiver's display. 2 To turn off Zone 2/3, press ZONE 2 or ZONE 3 followed by ON/STANDBY within 8 seconds. The zone is turned off. ■ Operating on the remote controller To control Zone 2/3, you must press ZONE2 or ZONE3 on the remote controller first. 1 Press ZONE2 or ZONE3, then point the remote controller at the AV receiver and press RECEIVER. Zone 2/3 turns on, the Z2 or Z3 indicator lights on the AV receiver's display. 2 To select an input source for Zone 2/3, press ZONE2 or ZONE3, followed by an INPUT SELECTOR button. 3 To turn off Zone 2/3, press ZONE2 or ZONE3, followed by RECEIVER. The zone is turned off. Adjusting the Volume for Zone 2 ■ Operating on the remote controller 1 Press ZONE2. 2 Use VOL R/X. ■ Operating on the AV receiver 1 Press ZONE 2 (the Z2 indicator on the AV receiver's display flash). 2 Use MASTER VOLUME control within 8 seconds. Tip • To unmute, press ZONE2 followed by MUTING again. Zone can also be unmuted by adjusting the volume. Note • Only analog input sources are output from the ZONE 2/ZONE 3 LINE OUT jacks and ZONE 2 L/R terminals. Digital input sources are not output. If no sound is heard when an input source is selected, verify that the source is connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. Namely, if you have selected an FM station for the main room, that station will also be output in Zone 2/3. • When you have selected NET or USB as input selector, the last selector selected will be set for Main room and Zone 2/3. • When Zone 2/3 is activated and its input selector is selected, the power consumption of standby mode slightly increases. • While Zone 2/3 is on, V functions will not work. • When setting the AV receiver to standby mode while Zone 2/3 is active, the Z2 or Z3 indicator is dimly lit. • "AUX", "EXTRA1" and "EXTRA2" cannot be selected as input sources for Zone 2/3. • When "AUX", "EXTRA1" or "EXTRA2" is the input source of Main room and Zone 2/3 is set to share the same source, no sound will be output from Zone 2/3. En-69