Onkyo S9100THX Owner Manual - Page 103
Tuner, Remote Controller, Recording, Others, an HDMI
UPC - 751398008283
View all Onkyo S9100THX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Troubleshooting-Continued There's no picture from a source connected to an HDMI IN • Reliable operation with an HDMI-to-DVI adapter is not guaranteed. In addition, video signals from a PC are not supported (page 35). • If the message "Resolution Error" appears on the AV receiver's display, this indicates that your TV does not support the current video resolution and you need to select another resolution on your DVD player. Tuner Reception is noisy, stereo FM reception suffers from hiss, or the FM STEREO indicator doesn't light up • Relocate your antenna. • Move the AV receiver away from your TV or com- puter. • When listening to an AM station, operating the remote controller may cause noise. • Passing cars and airplanes can cause interference. • Concrete walls weaken radio signals. • If nothing improves the reception, install an outdoor antenna. Remote Controller The remote controller doesn't work • Make sure that the batteries are installed with the cor- rect polarity (page 17). • Make sure that the remote controller is not too far away from the AV receiver and there's no obstruction between the remote controller and the AV receiver's remote control sensor (page 17). • Make sure you've selected the correct remote controller mode. • Make sure you've entered the correct remote control code (page 92). Can't control other components • Make sure you've selected the correct remote control- ler mode. • If you've connected an -capable Onkyo MD recorder, CD recorder, or RI Dock to the TAPE IN/OUT jacks, or an RI Dock to the CBL/SAT IN jacks, for the remote controller to work properly, you must set the Input Display to MD, CDR, or DOCK, respectively (see page 48). • The entered remote control code may not be correct. If more than one code is listed, try each one. • With some AV components, certain buttons may not work as expected, and some may not work at all. • To control an Onkyo component that's connected via , point the remote controller at the AV receiver. Be sure to enter the appropriate remote control code first (page 93). • To control an Onkyo component that's not connected via , or another manufacturer's component, point the remote controller at that component. Be sure to enter the appropriate remote control code first (page 92). Recording Can't record • On your recorder, make sure the correct input is selected. • To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT or VCR/DVR IN to VCR/DVR OUT). Others The sound changes when I connect my headphones • When a pair of headphones is connected, the listening mode is set to Stereo, unless it's already set to Stereo, Mono, or Direct, in which case it stays the same. How do I change the language of a multiplex source • On the Audio Adjust menu, change the Input Ch set- ting to Main or Sub (page 76). The functions don't work • To use , you must make an connection and an analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally (page 40). The following setting can be made for the S-Video and composite video inputs You must use the buttons on the AV receiver to change this setting. 1. While holding down the input selector button for the input source that you want to set, press the [SETUP] button. 2. Use the Left and Right [ ]/[ ] buttons to change the setting. 3. Press the [SETUP] button when you've finished. • Video Attenuation This setting can be made for the DVD, VCR/DVR, CBL/SAT, or AUX input. If you have a game console connected to an S-Video or composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:0: (default). Video ATT:2: Gain is reduced by 2 dB. 103