Onkyo S9100THX Owner Manual - Page 52
Using Headphones, Displaying Source Information, Press the [RECEIVER] REMOTE, MODE button
UPC - 751398008283
View all Onkyo S9100THX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Common Functions-Continued 7Using Headphones For private listening, you can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver's PHONES jack. ON/STANDBY STANDBY THX PHONES MULTI CH A SPEAKERS B Displaying Source Information You can display various information about the current input source as follows. DISPLAY Notes: • Always turn down the volume before connecting your headphones. • While the headphones plug is inserted in the PHONES jack, speakers sets A and B are turned off. • When you connect a pair of headphones, the listening mode is set to Stereo, unless it was already set to Mono, Stereo, or Direct, in which case it stays the same. • When the multichannel DVD input is selected, only the front left and front right channels can be heard in the headphones. Press the [RECEIVER] REMOTE MODE button, and then press the [DISPLAY] button repeatedly to cycle through the available information. Note: • This procedure can also be performed on the AV receiver by using its [DISPLAY] button. The following information can typically be displayed: Input source & volume*1 Signal format*2 or sampling frequency Input source & listening mode *1 When AM or FM radio is used, the band, preset number, and frequency are displayed. *2 If the input signal is analog, or AM or FM radio is selected, no format information is displayed. If the input signal is PCM, the sampling frequency is displayed. If the input signal is digital but not PCM, the signal format is displayed. Information is displayed for about 3 seconds, then the previous display reappears. 52